Solid wood furniture, plate, without a trial of strength

Wood species are not the only criterion for measuring the quality of wood

Select wood furniture, many people loved to ask, "What wood for?" In fact, apart from high cost of valuable wood species or exotic wood, the wood species used in furniture manufacturing is so much: frequently used such as oak, beech, walnut; less frequently used, such as maple or ebony, but often as a veneer and solid wood components appear local.

The timber used as an external framework, advanced with beech or oak wood, down there elm, catalpa wood, low-end and then there are fir, pine, etc.; and internal framework of the mostly man-made sheet. So if you want to identify good or bad wood, from the perspective of wood species question, unless the particular wood species, often with the answers are similar.

Truly reflect the quality of wood, however, often not just wood species, such as oak is also affixed skin, 0.6mm thick 0.2mm thick, compared to high-level lot; or ruled uniformly distributed clutter even better than the twill; again, or to fight Flower paste the entire post than skin skin stress, etc., which are hidden in the "oak paste skin" in the details of this simple term.

Solid wood, board, without a trial of strength

Solid wood and the plate that the two words in the selection of furniture, the frequency of the highest, but the people are always subconsciously to varying degrees, as a "solid wood expensive plate worthless," conclusion. The most important argument is the plate substrate is MDF furniture or particleboard, MDF or particleboard, but precisely because the performance was able to achieve solid wood edge can not and do, such as: large plate, material stability and to prevent, easy to break Fissile the phenomenon of resistance, Fog, and so designated. In addition, a solid wood furniture can come from a factory, you can also come from a workshop, but a plate of furniture to be out of a medium-sized factories,
As it involves a lot of equipment and assembly line, its investment is also very large. Therefore, the difference between plate and solid wood in the furniture industry is entirely a product specifications and technology to achieve the division, and the product itself has nothing to do equal status. Therefore, rather than the wood and the plate, it is better to wood and the plate inside the respective categories of products to compare.